Latest Construction Forum Topics:

  • As satellites are added and removed from the GPS system in the future, how does my GPS device system adapt? (4 posts)
  • Why do I have to wait 30 days to apply Thompsons water sealer to my new deck? (6 posts)
  • Need a new mattress - any advice? (9 posts)
  • Heating argument ;(? (5 posts)
  • DO these match? (6 posts)
  • Where can I find cheap modern/retro furniture? (7 posts)
  • wiring a celing fan and a light fixture I switched places whith each other.? (3 posts)
  • Living room decor? (7 posts)
  • polyurethane on a "wood" laminate floor?? (5 posts)
  • Contemporary Paint Color HELP!!!!? (4 posts)
  • Am I in a timewarp? (7 posts)
  • If I plug an outlet strip into a surge protector, will all of its outlets (including the RJ-11) be protected? (3 posts)
  • What color should I paint my room? (18 posts)
  • When I upgrade my propane tank from the old style P.O.L valve to the new acme type, will my heater still fit? (3 posts)
  • I just had a new liner and wedding cake stairs installed. The liner has large wrinkles around the stairs.? (2 posts)
  •  

    Free Standing Carport Plans

    Summary: This free standing carport plan produces a carport 20 x 10.

    Free standing carports have been a major appeal nowadays. One problem though, free standing carports cost a fortune. This free standing carport plan will show you how to make your own free standing flat roof carport. The materials to be used are quite cheap. And you could probably finish this in two days, depending on your speed. So save those bucks. Check on the highlighted materials. They don't cost as much as the carports sold over the internet.

    This carport plan produces a structure 20ft long and 10ft wide. The design is pretty basic since this carport plan only serves to show casual readers with interest in carports how to make own. Before engaging into this activity, check with your Local Authority to see if any permit or consent is required.

    Summarizing the materials needed

    Posts 4x4
    Beams 2x8
    End rafters 2x8
    Rafters 2x6
    Noggings 2x6
    Galvanized bolts
    Joist Hangers
    Galvanized Angle Bracket

    The roof slope should be at least 2". In this project the slope is 4". If using a clear PVC roof, then a steeper slope is advisable, as a steeper fall means faster water run-off, and therefore a cleaner roof.

    Mark out the carport (20ft x 10ft rectangle) and erect timber profiles out from each corner and also out from the middle to take in the two center posts. Set the timber profiles back at least 2'-O" from the building line (carport perimeter) to allow room for hole digging etc. Attach stringline to indicate the center of the six posts 4" in from the side edges and 13" in from the front and back edges.

    Dig holes 1"square 2" deep. Place 4" of concrete into the bottom of every hole. Now put the posts in the holes and check that the post is plumb (vertical) and almost, but not quite, touching the stringline.

    Fill the hole with concrete to within 2" of the finished ground level. Check again that the post is plumb and not quite touching the stringline. Because of the depth of the hole, the concrete will support the post without the need for bracing. Continue until all posts are concreted in.

    Mark the rear posts a minimum of 7'-8" above the slab, or finished ground level. Ensure the height marks on both rear posts are level. Use a spirit-level on a straight edge to achieve this or the water level method. Mark the front two posts 4" higher than the rear posts. Fix a stringline between the front and back posts to mark the height of the middle posts. Cut the tops of the posts off at these marks.

    Cut the two beams 20ft long with 45degree angle cuts each end and clamp in place to the posts so that the tops of the beams are flush with the tops of the posts and protrude past both the front and rear posts by 1'-0". Drill and bolt the beams to the posts with 1/2" Galvanized bolts, two bolts at each at each meeting.

    Cut the two end rafters 10ft long with 45degree angle cuts each end and fix in place to the beams with 3" jolthead Galvanized nails and then with Galvanized angle brackets, each bracket fixed with four 1/2" Galvanized bolts, two through the beam and two through the rafter.

    Cut the six intermediate rafters 9'-8" long and fix in place to the beams with Galvanized metal joist hangers. Space the rafters at 3'-0" center.

    Finish off with a longitudinal row of noggings down the middle and in between the rafters.

    If the posts are concreted into the ground, and the posts are bolted to the beams with two bolts at each meeting, then no further bracing should be required. If, however, the posts are not in-ground, but supported by Galvanized post brackets, then additional bracing is required. One such scenario is to fix upper post diagonal bracing two to each post, each about 3'-0" long (more or less), and fixed to the post with nailplates and fixed to the beam/rafter with bolts. You may now attach your choice of roof.

    This free carport plan is taken from:
    http://www.buildeazy.com/carport.html

    Sponsored Ads:

    Related Articles:

    Also In This Category:

    Currently Online :

    5 member(s), 32 guest(s):
    Biohazard, FollowTheLeader, FunnyFish, LighteningBolt, OldFriend, Ask Jeeves, Gigabot, Google, MSN.com, Nutch, Cobion.com, Slurp, Speedy Spider

    Search :

    No comments yet
    Categories: Tenant Screening Declutter your Home List Building Decorate Your Home Porches Decks How to Start Your Own Cellar Kitchen Care Home Inspection Boo-Boos Paint Tips For Your Home Bathroom Accessories Waterfront Property Air Purifiers Vacuum Cleaners Waterfront Property Swimming Pools Sell Your House Roofing Power Tools Energy Efficient Home Excavation Equipment Metal Detector Alternative Energy Ceiling Fans Mini Blinds Home Security Excavation Equipment Home Improvement Carpet Pool Accessories Carport Home Makeover Lighting Construction Management Windows Water Treatment Solar Energy Shipping Security Roofing Remodeling Patio Mattress Home Refinancing Home Inspector Home DIY Generators Garage Remodeling Excavation Machines Chandelier Bathroom Accessories Alarm Systems Woodworking Termites Siding Rugs Home Security Realtor Real Estate Moving Relocation Window Blinds Kitchen Remodeling Flooring Buying A New Home